Laatste berichten
-
00:15
[scheikunde] Kan chloorgas de geleiding van elektriciteit belemmeren? 9
-
22:27
positie 1
-
21:15
Weerfrustratie 9
-
18:24
Schroefdraad berekening 5
-
18:08
geen minkowski-ruimte toch? Doe ik dit nou fout? 15
-
14:16
do-re-mi-fa-so vliegtuigen 7
-
14:16
Kunnen quantum Zonnecellen 190% quantum efficiënt zijn 3
-
13:57
De Euro Nederlandse 100 qubit computer komt eraan
-
10:42
projectiel 8
-
10:37
Verschil tussen deze 2 vragen 5
-
09:25
[scheikunde] berekeningen labo vitamine c bepaling 1
-
22 apr
[wiskunde] rode en witte ballen verdelen 8
-
22 apr
Rotatie van het heelal 41
-
22 apr
Muntje opgooien 14
-
21 apr
Reactiviteit silyl enol ethers 1
-
21 apr
Criterium voor vochtretentie
-
21 apr
speciale rel. theorie 5
-
21 apr
Vogels in de stad zijn goede klussers
-
21 apr
Ervaringen met "herontdekkingen" 15
-
20 apr
Herleiden afmetingen vanaf een foto 19
Nieuwsberichten
-
04 mar
Een nieuw soort magnetisme: altermagnetisme
-
31 okt
AI kan via stem diabetes vaststellen 11
-
21 okt
Einstein krijgt wéér gelijk 45
-
07 feb
witter dan wit 20
-
19 jun
irrigatie en de aardas
Straling meten.
-
- Berichten: 3
Straling meten.
Ik wil graag de straling meten die vrijkomt in mijn huis/omgeving. Met name de omgeving van elektrische apparaten zoals computerkasten, monitoren, TV's etc. Er bestaan verschillende soorten straling, waar de specialisten allerlei verschillende apparaten voor gebruiken. Ik zoek een meet-apparaat die verschillende soorten straling kan meten, weet iemand toevallig een niet al te dure?
-
- Berichten: 48
Re: Straling meten.
kost je bijna nix, moet wel beetje elektronica ervaring hebben
Simple Geiger Detector uses neon Glow Lamp
In these times of increased terrorist threats, the possibility of some type of nuclear incident exists. By using a few simple components, it's possible to build a low-cost Geiger detector. Detecting α radiation requires a special Geiger tube. But for detecting only β and γ radiation, a neon glow lamp can be used.
Operation is as follows (see the figure): The alternating current is rectified by diode D1. A simple Zener-diode stabilization network circuit using D2 supplies a voltage of 100 V dc. The value of R1 depends on the source voltage and must be calculated with the equation, R1 = (V ac −s 100 V)/5 mA. Potentiometer R2 is used to set the detector voltage very close to, but slightly below, the neon lamp's ignition voltage. The lamp must not ignite. If a radioactive particle then ionizes the gas in the lamp, it ignites.
At that point, resistor R3 drops most of the voltage, so the lamp voltage is lower than the holding voltage. No additional current flows through the lamp until the next radioactive particle ignites it. During the small moments of current flow, a short and quiet clock noise comes out of the loudspeaker.
More circuits like this one can be found in my book about experiments with radiation sources (written in German), Experimente mit Strahlenquellen im Haushalt (www.peterlay.de).
Note: As with all circuits that can be connected directly to an ac power source, suitable insulation, grounding, and polarization precautions should be taken to avoid the risk of potentially lethal electric shock.[/b]
Simple Geiger Detector uses neon Glow Lamp
In these times of increased terrorist threats, the possibility of some type of nuclear incident exists. By using a few simple components, it's possible to build a low-cost Geiger detector. Detecting α radiation requires a special Geiger tube. But for detecting only β and γ radiation, a neon glow lamp can be used.
Operation is as follows (see the figure): The alternating current is rectified by diode D1. A simple Zener-diode stabilization network circuit using D2 supplies a voltage of 100 V dc. The value of R1 depends on the source voltage and must be calculated with the equation, R1 = (V ac −s 100 V)/5 mA. Potentiometer R2 is used to set the detector voltage very close to, but slightly below, the neon lamp's ignition voltage. The lamp must not ignite. If a radioactive particle then ionizes the gas in the lamp, it ignites.
At that point, resistor R3 drops most of the voltage, so the lamp voltage is lower than the holding voltage. No additional current flows through the lamp until the next radioactive particle ignites it. During the small moments of current flow, a short and quiet clock noise comes out of the loudspeaker.
More circuits like this one can be found in my book about experiments with radiation sources (written in German), Experimente mit Strahlenquellen im Haushalt (www.peterlay.de).
Note: As with all circuits that can be connected directly to an ac power source, suitable insulation, grounding, and polarization precautions should be taken to avoid the risk of potentially lethal electric shock.[/b]
There are 10 types of people in this world, those who understand binary and those who don't
